You are here: Home > Slicing, Dicing & Milling
Sort By:
Page of 3  
Mill
 

Product Code: 8248i

Koruma type GS4.  Stainless contact parts.  Previously used for grease.

Onsite
Slicer/Dicer
 

Product Code: 8287s

Bingham.  Includes 2x sets of 1/2" brass grids, 2x sets of 5/8" brass grids, side outlet, contact parts are stainless steel or brass.  2 hp, 1400rpm, 3 phase motor.  The product is fed into a circular blade via 4x tubes and then passes through the dicing grids.

Size:  O'all 1m W x 1.17m L x 1.64m high.

Offsite
Hammermill
 

Product Code: 7567s

Damrow, stainless steel.  Used for blocks of cheese.  Top mounted infeed, sits on base frame.  No motors fitted (main mtr was 50hp, 980rpm; feed gear mtr - 10hp, 70rpm).  Price in AUD$ ex site Australia. This price does not include packaging, freighting, insurance etc.

Offsite
Pin Mill
 

Product Code: 7639s

Jiyu M7 pulveriser.  There are 2 or 3 circles of pins fixed radially on a rotor.  The product is fed from the central part of the rotor and stator and is dispersed outwardly, crushing against the pins.  As the revolving speed increases (outer circles revolve faster than inner), the impact is heavier and particle size is reduced.  The hole diameter of the inner screen, number of rotor revs and the quantity of rotor pins determine the final particle size.  Requires 37kw, 4 pole TEFC motor (available for AUD$1,000).  Price per each in AUD$ ex site Australia. Packaging, freight, insurance not included.

Size:  Capacity up to 5 Ton/Hr

Offsite
Mill
 

Product Code: 7700s

Steel construction, mobile, 3 phase heavy duty gear motor drive with starter, safety switches.  Previously used for chocolate.  Price in AUD$, ex site Australia and does not include packaging, freight, insurance etc.

Size:  Mouth 365mm W x 250mm H.

Offsite
Mill
 

Product Code: 7851i

Mikro Pulveriser by Geo Adlam & Sons.  Type 1SH.  Cast iron, 3 phase.  Previously used to make icing sugar. There is a guard in the base of the hopper through which the granular product falls to an horizontal auger. The product is then augered into a hammermill chamber with a very fine screen. Screen could do with replacing.

Onsite
Prebreaker
 

Product Code: 7907s

Scott Rietz PB6, with 60hp motor/gearbox.  Some reconditioning about 5 years ago - used once since for trial. Chain driven. Also known as Rietz Extructor, model RE-24-H7E33

Size:  600mm throat.

Offsite
Slicer
 

Product Code: 7975i

Urschel CC with bronze head for crinkle crisps.

Onsite
Slicer for Fruit
 

Product Code: 7178s

Fruit is conveyed in on two 'V' belts to two circular blades. Cuts fruit in half.  Motor - Levoy Somer, 3 phase, 0.75hp.  No brand or model, requires control panel and electrics.

Offsite
Lumpbreaker
 

Product Code: 8246i

Painted steel, for powder.  Rectangular sections rotate on shaft as in hammermill.  Motor 2.2kw, 1400rpm.

Size:  Inlet diam 145mm, outlet.

Onsite